User's Manual

AC/DC Electronics Laboratory 012-05892A

➂ Click on the Frequency value to highlight it. Type in “0.30” as the new value. Press the “enter” key.

➃ Click the Scope display to make it active.

• You will change the rate at which the scope is sampling data.

➄ Click the “Horizontal Input” button. Use the Horizontal Input menu to select “Time Input” (at the

bottom of the list).

Horizontal Input button Horizontal Input menu

➅ Repeatedly click the “Decrease Sweep Speed” button ( ) until the Sweep Speed is 500.00

ms/div.

➄ Click the “Horizontal Input” button again. Use the Horizontal Input menu to select “Analog A” (at

the top of the list).

Horizontal Input button Horizontal Input menu

• After making changes, the Scope display should be similar to the figure below: