User's Manual

012-05892A AC/DC Electronics Laboratory

➄ The Signal Generator is set to output 3.00 V, triangle AC waveform, at 60.00 Hz.

➅ The Scope is set to show Output Voltage on the vertical axis at 1.000 v/div and Current (Analog

A) on the horizontal axis at 0.100 v/div.

➆ Arrange the Scope display and the Signal Generator window so you can see both of them.

PART II: Sensor Calibration and Equipment Setup

• You do not need to calibrate the Power Amplifier.

➀ Place a ten ohm (Ω) resistor in the pair of component springs

nearest to the banana jacks at the lower right corner of the

AC/DC Electronics Lab Board.

➁ Connect banana plug patch cords from the output of the

Power Amplifier to the banana jacks on the AC/DC Electron-

ics Lab Board.

➂ Turn on the power switch on the back of the Power Amplifier.

Part III: Data Recording – Resistor (10 Ω)

➀ Click the “ON” button ( ) in the Signal Generator

window.

➁ Click the “MON” button ( ) in the Experiment Setup

window to start monitoring data. Observe the Scope display

of Voltage and Current. Wait a few seconds, then click the

“STOP” button (

➂ Click the “OFF” button ( ) in the Signal Generator window. Turn off the power switch on

the back of the Power Amplifier.

3 VOLTS MAX

AC/DC ELECTRONICS LABORATORY

KIT NO.

to Power Amp.

10Ω

(brown, black, black)