User manual

audio professional Seite 5
FOREWORD
Congratulations! In purchasing our Limiter DS 22S you have acquired a limiter whose small
size belies its incredible versatility and superlative audio performance. Its excellent dynamic
range, the extremely low noise level and the outstanding price-performance ratio makes the
DS-22S Controller an advantageous altenative to conventional limiters and controller solutions -
even in the critical field of permanent installation.
Keep this reference manual carefully!
START / SETTINGS
XLR Input/Output connectors
The DS 22S Controller`s Inputs/Outputs are electronically balanced. (for connection help take a
look at page 8)
Internal direct 5-pin connectors (option)
There is also the possibility that the unit not connected to the rear panel XLR connectors with
power amplifiers / mixers, etc., but inside the device balanced cables directly without external
separable connector to connect. Unscrew the top cover, (power first disconnect from the
mains!) and connect the electrical cable through the rear opening devices to the internal
header. The label next to the bus bar shows the pin assignments. After adjusting the limiter,
the opening (threshold set) in the front panel could be sealed with the two red stickers, so that
a bridging of the device or manipulation only possible through the expansion and opening the l
top cover. (Demanded by labor inspectorates in use of the limiter as a volume limiter, for
example, in nightclubs).
Switches
Power-On Switch
Switching the AC-Mains. A red LED lights up at the front panel, if the power switch is at the
“ON” position.
INTE RN
bal.in/ou t
P IN 1 SH IELD
P IN 2 > +
P IN 3 > -
E LEC TR ONIC ALLY
BALA N CE D
INP UTS /O UTP UT S
INP UT I MP ED .
20 KO H M
OUT OUTIN IN CH.A CH.B