Installation Guide

www.partsmasterpro.com

1-877-542-2211

customerservice@theonlyagencyrep.com

58574B

The Agency ACBH assumes no responsibility

for failure due to improper use. PartsmasterPro

is a registered trademark of The Agency ACBH

www.partsmasterpro.com

Made in Taiwan

WARNING: Cancer - www.P65warnings.ca.gov

1. Turn off water supply.

2. Remove handle cap and retaining

screw, and remove handle by

pulling straight out.

3. Unthread and remove cap assembly.

4. Remove ball and cam by pulling up

on ball stem.

5. Replace ball, then place new cam

assembly (with rubber cam packing

below plastic cam) on top of ball.

Make sure that lug on side of cam is

inserted into slot on the side of the

faucet body. Tighten cap assembly securely.

6. Reassemble handle to faucet.

7. Turn on water and check for leaks.

Tools needed for installation:

• Adjustable Wrench • Screwdriver

Installation Instructions

PAGE 1
-877-542-2211 customerservice@theonlyagencyrep.com 58574B Installation Instructions 1. Turn off water supply. 2. Remove handle cap and retaining screw, and remove handle by pulling straight out. 3. Unthread and remove cap assembly. 4. Remove ball and cam by pulling up on ball stem. 5. Replace ball, then place new cam assembly (with rubber cam packing below plastic cam) on top of ball. Make sure that lug on side of cam is inserted into slot on the side of the faucet body. Tighten cap assembly securely. 6.