Installation Guide

©2018 The Agency ACBH. PO Box 178, West Grove, PA 19390
www.partsmasterpro.com
1-877-542-2211
[e-mail]
58509
Installation Instructions
1. Remove Overflow Plate Screws.
2. Carefully remove Overflow Plate and entire linkage assembly.
3. Install Overflow Plate Adapter using two screws from
the old plate.
4. Align screw hole on new Overflow Plate and
thread screw into place.
Tighten with screwdriver.
5. Remove Bath Shoe using a bath shoe removal tool.
Remove worn Tub Gasket.
6. Using a soft cloth, remove debris from inside
drain threads and the lip of the tub.
7. For 1-3/8” drains, remove plastic bushing/adapter
from new Bath Shoe threads and apply pipe thread
sealant onto metal outside threads of new Bath Shoe.
For 1-1/2” drains, keep plastic bushing/adapter on the
new Bath Shoe threads.
8. Install new Tub Gasket between the drain and the tub.
9. Apply plumber’s putty under the lip of the new Bath Shoe.
10. Unscrew Tip-Toe Stopper from new Bath Shoe. Install new
Bath Shoe and tighten with bath shoe wrench until plumber’s putty forms a seal.
11. With Tip-Toe Stopper in the open position, thread stopper into the new Bath Shoe.
Tools needed for Installation:
Screwdriver • Bath Shoe Wrench • Pipe Thread Sealant • Plumber’s Putty
Bath Shoe
Tub Gasket
WARNING: Cancer and Reproductive Harm - www.P65warnings.ca.gov