Installation Guide
©2018 The Agency ACBH. PO Box 178, West Grove, PA 19390
www.partsmasterpro.com
1-877-542-2211
customerservice@theonlyagencyrep.com
58470
Installation Instructions
1. Turn off water supply.
2. Remove handle cap and retaining screw.
3. Remove handle by pulling straight out.
4. Remove old ange by unthreading ange screws.
5. Remove sleeve.
6. Install sleeve.
7. Install new ange.
8. Install new handle on stem and tighten with retaining screw.
9. Turn on water supply.
Security Device Enclosed
WARNING: Cancer and Reproductive Harm -
www.P65warnings.ca.gov
©2018 The Agency ACBH. PO Box 178,
West Grove, PA 19390. All Rights Reserved.
The Agency ACBH assumes no responsibility
for failure due to improper use. PartsmasterPro
is a registered trademark of The Agency ACBH
Posi-Temp, Moentrol, Chateau, and Legend are
trademarks of Moen Incorporated.
www.partsmasterpro.com
Made in Taiwan
1. Turn off water supply.
2. Remove handle cap and retaining screw.
3. Remove handle by pulling straight out.
4. Remove old ange by unthreading ange screws.
5. Remove sleeve.
6. Install sleeve.
7. Install new ange.
8. Install new handle on stem and tighten with retaining screw.
9. Turn on water supply.
Security Device Enclosed
WARNING: Cancer and Reproductive Harm -
www.P65warnings.ca.gov
©2018 The Agency ACBH. PO Box 178,
West Grove, PA 19390. All Rights Reserved.
The Agency ACBH assumes no responsibility
for failure due to improper use. PartsmasterPro
is a registered trademark of The Agency ACBH
Posi-Temp, Moentrol, Chateau, and Legend are
trademarks of Moen Incorporated.
www.partsmasterpro.com
Made in Taiwan