Installation Guide

©2018 The Agency ACBH. PO Box 178, West Grove, PA 19390
www.partsmasterpro.com
1-877-542-2211
[e-mail]
58404
1. Turn off water supply.
2. Remove handle cap and retaining screw,
and remove handle by pulling straight out.
3. Unthread and remove cap assembly.
4. Remove ball and cam by pulling up on ball stem.
5. Remove existing seats and springs.
6. Install new springs and seats.
7. Replace ball, then place new cam assembly
(with rubber cam packing below plastic cam)
on top of ball. Make sure that lug on side of cam is
inserted into slot on the side of the faucet body.
Tighten cap assembly securely.
8. Reassemble handle to faucet.
9. Turn on water and check for leaks.
Tools needed for installation: • Adjustable Wrench • Screwdriver
WARNING: Reproductive Harm - www.P65warnings.ca.gov
Installation Instructions