Installation Guide

©2018 The Agency ACBH. PO Box 178, West Grove, PA 19390
www.partsmasterpro.com
1-877-542-2211
[e-mail]
58395B
1. Turn off water supply.
2. Using included allen wrench, partly unthread set screw,
and then pull off handle.
3. Unthread and remove cap assembly. Remove spout by
pulling straight up.
4. Remove existing ball and cam by pulling up on ball stem.
5. Remove existing seats and springs.
6. Remove existing faucet o-rings, and install new o-rings.
7. Install new springs and seats.
8. Install new ball, then place new cam assembly (with rubber
cam packing below plastic cam) on top of ball. Make sure
that lug on side of cam is inserted into slot on the side
of the faucet body.
9. Tighten cap assembly securely. Reassemble handle to faucet.
10.Turn on water and check for leaks.
Tools needed for installation: • Adjustable Wrench
WARNING: Cancer and Reproductive Harm - www.P65warnings.ca.gov
Installation Instructions