Installation Guide

©2018 The Agency ACBH. PO Box 178, West Grove, PA 19390
www.partsmasterpro.com
1-877-542-2211
[e-mail]
58366B
©2018 The Agency ACBH. PO Box 178,
West Grove, PA 19390. All Rights Reserved.
The Agency ACBH assumes no responsibility
for failure due to improper use. PartsmasterPro
is a registered trademark of The Agency ACBH
www.partsmasterpro.com
Made in Taiwan
WARNING: Cancer - www.P65warnings.ca.gov
1. Turn off water supply.
2. Using allen wrench, partly unthread
set screw, and then pull off handle.
3. Unthread and remove cap assembly.
4. Remove cam assembly.
5. Place new cam assembly (with rubber
cam packing below plastic cam) on top
of ball. Make sure that lug on side of cam
is inserted into slot on the side of the
faucet body. Tighten cap assembly securely.
6. Reassemble handle to faucet.
7. Turn on water and check for leaks.
Tools needed for installation:
• Adjustable Wrench • Allen Wrench
Installation Instructions