User's Manual

IC Card Read

1、 insert the IC card with the chip upward;

Torn Paper

1、Hand and hold the end of the paper along the cutter from left to right around 45

degrees angle of the direction of the tear, the force should be quickly and evenly.

Installation Of Paper

1、Open the paper bucket lid: Unlock the printer cover( ) by pulling the lever up;

2、Load the thermal paper after open the printer cover. Please notice the paper

come from bottom side;

3、Align the sheet of paper out into the guide slot of the cuter, press the printer

cover back until a "click" sound is heard;

4、To avoid a paper jam or damage the printer, please use standard printing paper

provided by the bank.

Notice

1、Use an outlet with a fuse;

2、Do not damage the power cord and adapter. They can not be used if damaged; 3、

When error occurs, please contact technical support. User's attempting to repair

the device is not covered within warranty;

4、Before connecting the AC power cord to a power supply outlet, you should check

voltage;

5、Do not insert anything into any of the interface of the device, it will seriously

damage the device;

6、Do not place the device in direct sunlight, high temperature, humid or dusty place;

7、Please stay away from liquids

8、Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation.