Data Sheet

2018/11/15 Particle Datasheets | Xenon datasheet
https://docs.particle.io/datasheets/mesh/xenon-datasheet/ 5/22
powering over this pin, please connect the ENABLE pin to GND so that the on board
regulator is disabled.
There are two options for the Mesh antenna on the Xenon. It comes with an on-board PCB
antenna which is selected by default in the device OS and a u.FL connector if you wish to
connect an external antenna. If you wish to use the external antenna, you'll need to issue
an appropriate command in the firmware.
The following antenna is optional, as the Xenon comes with an on-board PCB antenna.
Particle Device Frequency Antenna Type Manufacturer MFG. Part # Gain
Xenon 2400-2500 MHz PCB Antenna Particle ANT-FLXV2 2.0dBi peak
Peripheral Type Qty Input(I) / Output(O)
Digital 20 I/O
Analog (ADC) 6 I
UART 1 I/O
SPI 1 I/O
I2C 2 I/O
USB 1 I/O
PWM 8 O
Note: All GPIOs are only rated at 3.3VDC max.
The Xenon has a dedicated 10 pin debug connector that exposes the SWD interface of
the nRF5280. This interface can be used to debug your code or reprogram your Xenon
Antenna
FCC approved antenna
Peripherals and GPIO
SWD