Data Sheet

2018/11/15 Particle Datasheets | Xenon datasheet
https://docs.particle.io/datasheets/mesh/xenon-datasheet/ 20/22
End equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain
laptop configurations or co-location with another transmitter), then the FCC authorization
is no longer considered valid and the FCC ID can not be used on the final product. In
these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling The final end product must be labeled in a visible area with the
following:
Contains FCC ID: 2AEMI-XENN
Manual Information to the End User The OEM integrator has to be aware not to provide
information to the end user regarding how to install or remove this RF module in the user’s
manual of the end product which integrates this module.
Canada Statement This device complies with Industry Canada’s licence-exempt RSSs.
Operation is subject to the following two conditions:
1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
1. l’appareil ne doit pas produire de brouillage;
2. l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
Caution Exposure: This device meets the exemption from the routine evaluation limits in
section 2.5 of RSS102 and users can obtain Canadian information on RF exposure and
compliance. Le dispositif répond à l'exemption des limites d'évaluation de routine dans la
section 2.5 de RSS102 et les utilisateurs peuvent obtenir des renseignements canadiens
sur l'exposition aux RF et le respect.
The final end product must be labelled in a visible area with the following: The Industry
Canada certification label of a module shall be clearly visible at all times when installed in
the host device, otherwise the host device must be labelled to display the Industry