integration Guide

ACCESSORIES
SOFTWARE
POWER SUPPLY
It is recommended to use Parrot Sequoia
on the Parrot’s fixed wing drones: Parrot
Disco Pro AG & Sensefly eBee SQ, which
benefit from a full, hardware, mechanical and
software integration. If you want to integrate
Parrot Sequoia on a dierent drone, please
first refer to the sensors positioning section.
PTP COMMANDS
PTP protocol has been standardized as ISO 15740. The standard can be found at www.iso.org
Parrot created an ocial PTP Extension for Parrot Sequoia. Please refer to the Parrot PTP
Extension document to find out about these specific commands.
INTEGRATION KITS
Micasense developed integration kits for the
3DR Solo and the DJI Phantom 3.
Learn more at www.micasense.com/accessories
HTTP COMMANDS CF DEV.PARROT. SEQUOIA
Parrot Sequoia also supports HTTP. Please refer to Parrot Sequoia page at developer.parrot.
com to learn more about HTTP commands on Parrot Sequoia.
SD CARDS
It is recommended to use only the cables
provided with the Parrot Sequoia sensor.
Please refer to the list of compatible SD cards
in the Parrot Support page.
PIXHAWK INTEGRATION CF CAMREMOTE
Parrot Sequoia can be triggered by the drone thanks to the autopilot hardware Pixhawk.
Integrating of Parrot Sequoia to the Pixhawk needs a remote control device that will host the USB
connection.
VP-Systems provides a small hardware device called CAMremote that allows Parrot Sequoia to be
triggered by PixHawk.
Lean more about the Pixhawk at pixhawk.org.
Lean more about CAMremote at vp-systems.eu.