Installation Instructions

English
Install the UNIKA interface between the Parrot MKi electronic box and the
vehicle wiring as described on the diagrams p.4 / 6.
Warning : Connect the ignition to the Parrot car kit if the vehicle is
based on a resistive or a K-Bus protocol. Don’t connect the ignition
if the vehicle is based on a CAN protocol as this signal is supplied by
the Parrot UNIKA.
Installing the
UNIKA with a
Parrot MKi
We recommend you to install the Parrot MKi / RKi / ASTEROID •
before installing the UNIKA.
Make sure the installation is correctly performed by checking if the •
«Good bye» message is displayed when you turn off the ignition.
► Refer to the documentation of your Parrot MKi / RKi / ASTEROID
for more information.
Installation
of the Parrot
MKi / RKi /
ASTEROID
Selecting the
protocol
Use the DIP switches on the UNIKA as indicated on the diagrams p.8
to select the protocol (resistive or CAN Bus / K-BUS) on which the vehicle
is based.
► If you do not know on which protocol your vehicle is based, refer to the
installation section of our website.
Warning: Make sure the Parrot UNIKA is not powered before selecting
the protocol.
UNIKA is a universal interface that allows you to control the Parrot MKi / RKi / ASTEROID
directly with the OEM steering wheel commands. UNIKA can work with car protocols such
as CAN, K-BUS or resistive systems.
► Refer to the installation diagrams p.4 to 8. For more information, refer to the Installation
section of our website www.parrot.com.
Installation
Warning : We advise our customers to have the Parrot system fitted by a professional.
10