User's Manual

ENGLISH

PAIRING WITH ERICSSON R520M ,T39/T39M,T68/T68M, SONYERICSSON

T68I

IMPORTANT: for Ericsson T39/T39m, R520m, T68/T68m and SonyEricsson T68i, the infrared (IrDA) sensor has to be

disabled for CK3000 to operate. Comply with the following recommendations: Go into the Menu, go to "Extras" or

“Connect”;  until " Infrared port", press "Yes", then  until "Disabled" and confirm by pressing "Yes".

After turning on the ignition of your car, carry out the following sequence for Ericsson R520m, T68/T68m and T39/T39m

telephones.

For the T68/T68m and T68i, go to "Connect", then "Bluetooth", then follow the instructions below.

For the R520 and the T39/T39m, press  until "Extras", until " BluetoothTM " and press "Yes".

 Until "Paired devices", press Yes.

 "Add devices", " Yes ". "Phone initiate", press " Yes ". "Headsets", press "Yes", then "Prepare headset" is displayed.

"Searching" is displayed.

When "Parrot CK v..." is displayed, click on "Yes".

"Add to Parrot devices" - press "Yes".

"Connection key" or “Enter Password” is displayed, enter 1234, then press "Yes".

The connection phase is now complete and "Pairing succeeded" is displayed on your screen.

For SonyEricsson T68i initial synchronization is manual. Please, go to the phone Menu  “Connect”  “Accessories”.

Press “Yes” and “HBH” is displayed. Press “Yes” and your phonebook will synchronize with CK3000. From now on, in place

of “HBH” you’ll see “Parrot Menu”.

PAIRING WITH ERICSSON T610

You need to pair devices when powering up CK3000 for the first time or after resetting your hands free. Subsequently, all

connections between your phone and the car kit are automatically established when both devices are within a few meters

range of each other. A 'beep' is heard when the connection is established.

IMPORTANT: Check that the lights on the red and green buttons come on and off according to the position of the ignition

key. With the T610, it is necessary to deactivate the infrared link (IrDA) for the CK3000 to work. Proceed according to the

following steps”

Connections, Activation IR, select “Deactivate” and validate by clicking on “ Selection”.

Your phone is on. Turn on the ignition key. Proceed with the following sequence to do the pairing

• Select “ Connections”, then “Bluetooth”.

• The pairing is done through “HandsFree” or “My Peripherals”

• Select “Handsfree”, validate by clicking on “Selection”

• “Add a handsfree device?” is indicated on the display, validate with “Yes”

• or alternatively, Select “My Peripherals”, validate by clicking on “Selection”

• New Peripheral, click on “Add”

• “Check if the Handsfree is in the correct mode and if you have the passkey”,OK

• “Searching for handsfree devices” is displayed, just wait.

• The T610 looks for all devices equipped with a handsfree profile.

• Then, “ Parrot CK v…” is displayed, validate by clicking on selection

• Enter 1234 as passkey, click OK.

• The pairing phase comes to an end and “Parrot CK V…added to my peripherals” is displayed.

Using Phone-specific Features

To synchronize your phonebook to your CK3000, follow the steps hereafter:

Connections, Accessories, Parrot Menu.

For detailed instructions, consult the user’s guide of the T610.

ERICSSON & Son

Ericsson