User's Manual

ENGLISH
12
USING PHONE-SPECIFIC FEATURES
Your phone provides DriveBlue management and settings from its accessories menu. Also refer to the Standard Features section.
Auto Answer
:
• From your phone, open the lid, select the PHONE shortcut.
• Click the EDIT option, click PREFERENCES.
• Click HANDSFREE, select AFTER 5 SECONDS from ANSWERING MODE list.
• Escape by clicking DONE several times.
Training names :
Your phone lets you assign voice tags to any phonebook entry. With Parrot CK3000, you can use those tags to call your
contacts, press the PICK UP button and say the name after hearing the 'beep'.
• From your phone, open the lid, select the PHONEBOOK shortcut.
• Select a name from the list, click the EDIT option, click EDIT CONTACT.
• Click the VOICE DIALING shortcut, click RECORD, and speak after the tone.
• Escape by clicking DONE several times
Training names: Record while holding the phone to your ear.
Answer/Busy voice commands :
Your phone lets you pick up or reject incoming calls using vocal commands. You must first record the two vocal commands
corresponding respectively to “Answer” and “Busy”.
You must first activate the answer/busy voice commands with the following steps:
• From your phone, open the lid, select the TELEPHONE icon in the toolbar.
• In the EDIT menu, select PREFERENCES.
• In the VOICE CONTROL item, activate the option VOICE COMMAND.
Answer/Busy voice commands: Please note that, when this option is activated, you will not hear the rings from incoming
calls from the kit, but only from the telephone itself. Rings from the kit are deactivated to let you use the voice commands
option.
CALLER ID
During an incoming call, your phone can identify and say the name of the caller if the phone number of the incoming call
has been first recorded in the phonebook and associated with a voice tag.
You must first activate the caller ID option with the following steps:
• From your phone, open the lid, select the TELEPHONE icon in the toolbar.
• In the EDIT menu, select PREFERENCES.
• In the VOICE CONTROL item, activate the option CALLER ID
RESETTING
RESETTING CK3000 IS DONE BY PRESSING GREEN AND RED BUTTONS AT THE SAME TIME. THAT APPLIES
TO ALL PHONES.
CAUTION: Resetting the system will entail a new pairing phase and erase all memory.
TROUBLESHOOTING
PROBLEMES SOLUTIONS
CK3000 says: "Bluetooth connection problem" Switch off your telephone, then switch it on again
if CK3000 stops responding to commands.
Your telephone does not detect the hands-free kit Switch off your telephone, and then switch it back
on again. Check that the BluetoothTM connection
of your telephone is enabled*.
Your telephone is not detected. Repeat the connection phase.
The person you are calling complains of an echo during
communication.
Reduce the communication volume.
Refer to the manual of your Ericsson or SonyEricsson telephone, if necessary
ERICSSON & Son
y
Ericsson