Operation Manual

47Pre-installed applications
Pre-installed applications
Installing the screen
Warning: Avoid any installation which could hinder the use of any important command or
hinder the driver's visibility. Do not install the Parrot ASTEROID Tablet in the airbag
deployment area or in a possible head impact area. Make sure it is not exposed to the air
stream from air vents.
The cradle can be mounted on the windscreen or on the circular part which is to be
stuck on the dashboard. Make sure the selected location is easily accessible while you
are in a driving position.
To make sure the adhesive tape adheres well :
select the support location carefully: once stuck, it will be difficult to change it
without affecting the fixation quality ;
clean the area with an appropriate cleaning product before sticking the support ;
once you have stuck the support on the dashboard, wait for approximately 2 hours
without handling it.
To mount the cradle, clean the selected location and press the suction cup against the
windscreen or the circular part and lift the locking lever until the mounting kit is
correctly fixed.
The cooling and heating cycle inside your vehicle may cause the suction cup to detach
from the windscreen. Make sure the suction cup is properly affixed to the windscreen
each time you use the Parrot ASTEROID Tablet. If it is not the case, the device may fall
whilst driving. Clean the windscreen and reinstall the suction cup if necessary.
Install the screen on the mounting kit starting with its lower magnetic part.