User manual
Table Of Contents
- Using this guide
- About ANAFI Ai documentation
- Prerequisites
- Foreword
- Disclaimer
- Technical specifications
- Package contents
- Presentation of ANAFI Ai
- Presentation of Parrot Skycontroller 4
- 4G Connectivity
- Data sharing and User accounts
- Obstacle avoidance
- Calibrations
- Pre-flight reminders
- Getting started
- Taking off
- Flying
- Returning home: Smart RTH
- Landing
- Smart LiPo Battery
- Media retrieval
- Introducing FreeFlight 7
- Settings
- Advanced Settings
- Videos, Photos and Panoramas
- Gimbal tilt and zoom controls
- Advanced imaging
- Missions: Piloting
- Missions: Photogrammetry
- Missions: Flight Plan
- Missions: Cameraman
- Missions: Vehicle
- Missions: Touch & Fly
- Flight logs and projects management
- Maintenance and Troubleshooting
- Appendix 1: Operational Checklist
V7.4.1.0 – published on December 20, 2022 27
Installing and retrieving the nano SIM card
The nano SIM card slot of ANAFI Ai is located on the right side of the drone, under the “4G” cover. To install
the nano SIM card, lift the cover open and insert the nano SIM card straight into the slot, shortest side first
and connectors turned to the back of the drone – refer to the diagram inside the 4G cover. To retrieve the
nano SIM, press the card and extract it.
Activating the nano SIM card
To activate the nano SIM card, power the full ANAFI Ai ecosystem (drone, Skycontroller 4, device) on as you
would for a flight.
Access the ANAFI Ai page of the dashboard. Top right of the interface, the “Cellular access” tile displays “Sim
locked” as on the following screenshot.
Tap the “Cellular access” tile to access the interface shown in the following screenshot.
Cellular access interface
If applicable, tap “Enter PIN” to access the “SIM card PIN” interface.
Drone page: SIM locked