User manual

V7.4.1.0 – published on December 20, 2022 122
Press and hold the controller’s Take-off/Landing, Optics reset and Media recording buttons for 15
seconds, then release the 3 buttons – note that the LED starts flashing after 10 seconds, but hold the
buttons for 5 seconds more.
The Skycontroller 4 reboots. The reset is successful.
The same procedure can be carried out safely, even with a drone connected, through the “Reset”
button of the Skycontroller 4 page, in FreeFlight 7.
Resetting the smart battery (reminder)
If the behavior of your battery is not consistent with the elements contained in the “SMART LIPO BATTERY”
section of this guide, and if you cannot get it to power your ANAFI Ai, you must reset your battery: plug it to
a power source with one of the enclosed cables, then keep the battery’s power button pressed for 15
seconds (regardless of the behavior of the LEDs), and release the button.
The battery’s LEDs flash quickly, one after the other, alternating green and red: the reset is successful.
To guarantee lasting best performance, Parrot recommends replacing smart batteries after 300
charge/discharge cycles.
Recover ANAFI Ai
In case of worrying situation, please follow the next steps:
1. Press the RTH button on the Parrot Skycontroller 4.
2. If it doesn’t work, attempt to issue an Automatic landing by pressing the Take-off/Landing button on
the Parrot Skycontroller 4.
3. Try to locate the ANAFI Ai position.
4. Check this unlikely event won’t cause a subsequent hazardous situation(s) based on its last know
position.
5. If there is a reasonable expectation that the loss of control will cause injury to a person, please
contact the emergency services.
Worrying situation might result to a non-respect of the normal utilization of the ANAFI Ai. Please read and
respect the operational requirements describe in the checklist appendix 1.
FreeFlight
7
:
Position of the reset button on the
Skycontroller 4
page