User manual

V7.4.1.0 – published on December 20, 2022 121
Resetting ANAFI Ai
Resetting ANAFI Ai reverts the drone back to its latest firmware update: it cleans all media, logs and
credentials from the drone. For this reason, remember to back up all your “Drone memory” FreeFlight 7
media before resetting ANAFI Ai.
To reset ANAFI Ai, press and hold the drone’s power button for approximately 10 seconds, until one
of the LED flashes in red, then release the button immediately.
The drone reboots. The reset is successful.
The same procedure can be carried out through the “Reset” button of ANAFI Ai’s page, in FreeFlight
7.
FreeFlight 7: Position of the reset button on the ANAFI Ai page
Turn-off ANAFI Ai
Press the power button of ANAFI Ai and hold it for approximately 3 seconds (until all the battery’s LEDs light
off) to turn it off.
Some visual indications can help you to determine if your ANAFI Ai does not turn-off:
1. Battery’s LED status: whether they are light on or not
2. If the gimbal is stabilized, it proves that the ANAFI Ai is still turn-on.
3. The top-central fan is running
4. The lateral LEDs are still blinking
A solution to be sure that the ANAFI Ai is well switched-off is to remove the battery from the body of the
drone (before, check that the drone is safe landed on the ground, without any running propeller).
Resetting the Skycontroller 4
Resetting the Skycontroller 4 reverts the controller back to its latest firmware update: it cleans all logs and
credentials, and restores the original ecosystem’s Wi-Fi SSID and password.
• To reset the Skycontroller 4, make sure no drone is connected to the controller, or the drone will initiate
a take-off sequence.