User manual
Table Of Contents
- Using this guide
- About ANAFI Ai documentation
- Prerequisites
- Foreword
- Disclaimer
- Technical specifications
- Package contents
- Presentation of ANAFI Ai
- Presentation of Parrot Skycontroller 4
- 4G Connectivity
- Data sharing and User accounts
- Obstacle avoidance
- Calibrations
- Pre-flight reminders
- Getting started
- Taking off
- Flying
- Returning home: Smart RTH
- Landing
- Smart LiPo Battery
- Media retrieval
- Introducing FreeFlight 7
- Settings
- Advanced Settings
- Videos, Photos and Panoramas
- Gimbal tilt and zoom controls
- Advanced imaging
- Missions: Piloting
- Missions: Photogrammetry
- Missions: Flight Plan
- Missions: Cameraman
- Missions: Vehicle
- Missions: Touch & Fly
- Flight logs and projects management
- Maintenance and Troubleshooting
- Appendix 1: Operational Checklist
V7.4.1.0 – published on December 20, 2022 102
Repeat earlier procedures to program the inspection of the third lighthouse and transit WP back to
the take-off area.
Obviously, Flight Plans can take any shape or form and the last WP does not have to be close to the
take-off area: you can start and finish a Flight Plan in different locations.
• However, if you want to land away from your take-off area, remember to select “No” Final RTH from
the Flight Parameters – refer to the “Flight Parameters” section of this chapter for details.
Flight Plan: Image parameters
The Flight Plan is complete. As you can see on the next screenshot, FreeFlight 7 estimates it will take about
17’40’’ to complete the 4.8 km flight. Time to set the Image parameters.
Tap the “Image parameters” box to open the corresponding interface.
WP #17 moved to stay consistent
with a
-
5
.0
° camera angle
Flight Plan complete