User manual
Table Of Contents
- Using this guide
- About ANAFI Ai documentation
- Prerequisites
- Foreword
- Disclaimer
- Technical specifications
- Package contents
- Presentation of ANAFI Ai
- Presentation of Parrot Skycontroller 4
- 4G Connectivity
- Data sharing and User accounts
- Obstacle avoidance
- Calibrations
- Pre-flight reminders
- Getting started
- Taking off
- Flying
- Returning home: Smart RTH
- Landing
- Smart LiPo Battery
- Media retrieval
- Introducing FreeFlight 7
- Settings
- Advanced Settings
- Videos, Photos and Panoramas
- Gimbal tilt and zoom controls
- Advanced imaging
- Missions: Piloting
- Missions: Photogrammetry
- Missions: Flight Plan
- Missions: Cameraman
- Missions: Vehicle
- Missions: Touch & Fly
- Flight logs and projects management
- Maintenance and Troubleshooting
- Appendix 1: Operational Checklist
V7.4.1.0 – published on December 20, 2022 100
The third lighthouse is inside the village, which cannot be flown over. On the next screenshot, reaching WP
#16 in a straight line implies flying too close from houses. This gives the opportunity to check the Segment
interface.
Tap a segment to activate the Segment interface: you can modify the speed of ANAFI Ai for any flight
segment (from 0.5 m/s to 12 m/s by 0.5 m/s increments – default value: 5 m/s).
Tap the “+” on the middle of the segment to create a new WP there: note that by default, the altitude
of the new WP considers flight level change between the WP before and the next WP.
Tap and slide the new WP to move it away from the village.
New WP created
Segment
interface activated