T-28 Trojan 1.1m Manual
8
EN
Battery Installation and ESC Arming
Battery Selection
We recommend the E-fl ite
®
1800mAh 11.1V 3S 30C Li-Po battery
(EFLB18003S30). Refer to the Optional Parts List for other recommended
batteries. If using a battery other than those listed, the battery should be within
the range of capacity, dimensions and weight of the E-fl ite Li-Po battery packs
to fi t in the fuselage. Be sure the model balances at the recommended CG.
1. Apply the loop side (soft side) of the hook and loop tape (A) to the bottom of
your battery.
2. Lower the throttle and throttle trim to the lowest settings. Power on the
Transmitter, then wait 5 seconds.
3. Carefully lift the back of the canopy hatch (B) to remove.
4. Install the fully charged battery (C) in the battery compartment as shown.
See the Adjusting the Center of Gravity instructions for more information.
5. Make sure the fl ight battery is secured using the hook and loop strap.
6. Connect the battery to the ESC (the ESC is now armed).
• The ESC will sound 3 tones (refer to step 6 of the binding instructions for
more information).
• An LED will light on the receiver.
If the ESC sounds a continuous double beep after the fl ight battery is
connected, recharge or replace the battery.
7. Reinstall the canopy hatch.
CAUTION: Always
keep hands away
from the propeller. When
armed, the motor will turn
the propeller in response
to any throttle movement.
A
B
C
SAFE® Select Switch Designation
SAFE® Select technology can be easily assigned to any open switch (two or
three position) on the transmitter. With this new feature, you now have the
fl exibility to enable or disable the technology while in fl ight.
IMPORTANT: Before assigning your desired switch, ensure that the travel for
that channel is set at 100% in both direction.
Assigning a switch
Bind the aircraft correctly to activate SAFE Select. This will allow the system to
be assigned to a switch.
Hold both transmitter sticks to the inside bottom corners and toggle the desired
switch fi ve times (one toggle = full up and down) to assign that switch. The
control surfaces of the aircraft will move, indicating the switch has been
selected.
Repeat the process to deselect the switch or to assign a different switch if
desired.
TIP: SAFE Select is assignable on any unused Channels 5–9.
Mode 1 and 2 Transmitters
two or three position switch
x 5
100%
100%