T-28 Trojan 1.1m Manual

Preﬂ ight

Model Assembly

1 Remove and inspect contents.

2 Read this instruction manual thoroughly.

3 Charge the ﬂ ight battery.

4 Fully assemble the airplane.

5 Install the ﬂ ight battery in the aircraft (once it has been fully charged).

6 Check the Center of Gravity (CG).

7 Apply Dual Rate values to your transmitter

8 Bind the aircraft to your transmitter.

9 Make sure linkages move freely.

10 Perform the Control Direction Test with the transmitter.

11 Adjust ﬂ ight controls and transmitter.

12 Perform a radio system Range Test.

13 Find a safe open area to ﬂ y.

14 Plan ﬂ ight for ﬂ ying ﬁ eld conditions.

Wing Installation

1. Remove the canopy from the fuselage.

2. Turn the wing and fuselage so their bottom sides face up.

3. Place the wing’s aileron servo connectors (A) into the rectangular hole in

the fuselage.

4. Slide the two guide pins (B) of the wing into the two holes in the fuselage.

5. Align and attach the wing to the fuselage using a screw (C).

6. Inside the fuselage, connect both aileron servo connectors to the aileron

Y-harness. There is no difference between the two connections on a

Y-harness. Left and right servo connectors do not have to be connected to a

particular side of a Y-harness.

7. When needed, disassemble in reverse order.

CAUTION: DO NOT crush or otherwise damage wiring when attaching

the wing to the fuselage.

3 X 25mm