T-28 Trojan 1.1m Manual

ManualsBrandsParkZone ManualsHobbyT-28 Trojan 1.1m BNF Basic w/AS3X and SS

Motor Service

Nose Gear Service

CAUTION: Always disconnect the ﬂ ight battery before performing

motor service.

Disassembly

1. Use a tool to remove the spinner nut (A) from the collet (B).

2. Remove the propeller (C), backplate (D) and collet from the motor shaft.

3. Remove three screws (E) from the cowling (F).

4. Carefully remove the cowling from the fuselage. Paint may keep the

cowling attached to the fuselage.

5. Remove four screws (G) from the motor mount (H) and fuselage.

6. Disconnect the motor wires from the ESC wires.

7. Remove four screws (I) and motor (J) from the motor mount. Keep the

rubber washers attached to the motor mount when removing the screws

and motor from the motor mount.

Assembly

Assemble in reverse order.

• Correctly align and connect the motor wire colors with the ESC wires.

• Install the propeller with the size numbers (9.5 x 7.5) facing out from the

motor.

• A tool is required to tighten the lock nut on the collet.

2X5mm (3)

CDB F

Hard landings may damage the nose gear. Replace damaged parts as needed.

CAUTION: DO NOT handle the propeller while the ﬂ ight battery is

connected to the ESC. Personal injury could result.

1. Remove the canopy from the model.

2. Disconnect the ﬂ ight battery from the model.

3. Disconnect the steering clevis from the rudder servo arm.

4. Remove the propeller and cowling from the model. (As shown in the

“Motor Service” section of this manual.)

5. Loosen the nose gear screw and remove the strut.

6. Remove the two screws (A) and steering arm retainer (B) (PKZ4408,

retainer with steering arm) from the ﬁ rewall.

7. Pull the steering linkage (C) forward and remove the Z-bend end (D) of

the linkage from the steering arm (E) (PKZ4408, including steering arm

retainer).

8. Reinstall the steering arm on the Z-bend end of the linkage.

9. Install the steering arm in the ﬁ rewall using the steering arm retainer and

two screws.

10. Connect the linkage clevis to the rudder servo arm.

11. Install the strut using the screws.

12. Reinstall the cowling, propeller and canopy on the model.

NOTICE: Always make sure the steering linkage clevis is adjusted correctly to

ensure the model steers straight when the rudder control is at neutral.

2.5X12mm (2)

Not all wiring

shown.

1.5X10mm (4)

3X10mm (4)

HGJ