User Manual

4
Attaching the Horizontal Stabilizer and
Rudder
1. Locate horizontal stab.
2.
Carefully slide horizontal stab into fuselage, making
su
re control surface horn is on top.
3.
Use included strips (4 pieces) of clear tape to
secu
re stab to tail fillet. You should use 1 strip for
top
and bottom of each side.
4.
Locate rudder. Carefully snap tail wheel wire into
the
clip on bottom of fuse, as shown.
5.
Use the three pins that are supplied to connect
rudder
to stab, as shown. Do this by pushing pins
in
carefully.
6.
Install keepers on backside to secure pins,
as shown.
7.
Attach rudder and elevator pushrods to
respective control horns (outer holes of control
horns
for both).
Note: It may be necessary to re-trim control
su
rfaces prior to flight.
Apply Tape
Step 2
Step 4
Step 5
Step 6
Step 7
Step 4
Step 3