Operation Manual

63
GB
Trouble shooting
  
Device does not start
Mains voltage is not present
Check plug socket, cable, line,
plug and fuse, where appropriate,
repair through electrical specialist
Defective on/off switch
Repair through customer serviceWorn carbon brushes
Defective motor
Blowing/suction pipe (2) is
not completely tted
Install a two-part blowing/suction
pipe
Impeller wheel cover still
open (
D
25)
Close impeller wheel cover and
screw it down properly
Device works with
interruptions
Damaged power cable
Check cable; where appropriate,
replace
Internal loose connection
Repair through customer service
Defective on/off switch
Low suction capacity
or suction not present
Collection bag (18) is full Empty collection bag
Collection bag is dirty Clean collection bag
Selector switch (16) in incor-
rect position
Set selector switch to the
suction symbol
Device clogged up or
blocked by foreign bodies
Remove plug or blockages (see
“Cleaning and Maintenance”)
Small or missing
blowing power
Selector switch (16) in incor-
rect position
Set selector switch to the
blowing symbol
Airstream regulator (10) in
incorrect position
Rotate airstream regulator to high
position
Device works with
interruptions
Foreign body blocks impel-
ler wheel
Remove blockage (see chapter
Cleaning and Maintenance)