User Manual
Table Of Contents
- 1.0 Introduction
- 2.0 Wiring Diagram
- 3.0 Testing
- 4.0 TROUBLESHOOTING
- 5.0 CARE AND MAINTENANCE
- 6.0 USING CONTROLLER TO CHANGE OUTPUT RESOLUTION
- 6.1 "QUICK CHANGE" DEFAULT SETTINGS
- 6.2 MENU CHANGE INSTRUCTIONS
- 6.3 Change the Default Mirror Image to Real Image (To use camera as forward facing or use with DVR).
- 6.4 HYBRID CAMERA
- 6.5 setting up the menu
- 6.6 LENS
- 6.7 EXPOSURE
- 6.8 BACKLIGHT
- 6.9 WHITE BALANCE
- 6.10 BLACK AND WHITE IMAGE
- 6.11 NR (Noise Reduction)
- 6.12 ADJUST
- 6.13 EXIT
- 7.0 CARE AND MAINTENANCE
- 8.0 Warranty Terms & Conditions
- 9.0 NOTES
54
3.0 TESTING
3.1 HOW TO TEST
1. Apply the parking brakes. (Safety Precaution)
2. Turn ignition on. (DO NOT TURN ON VEHICLE)
3. Shift into reverse gear.
4. Image should appear on the monitor.
4.0 TROUBLESHOOTING
PROBLEM SOLUTION
“No Signal” appears while
reversing
1. Check video input
connections
2. Check camera power
connections
Video image is not sharp Check camera lens for debris
5.0 CARE AND MAINTENANCE
Always keep camera clear from dirt and mud. Clean camera with a
soft moist cloth.
6.0 USING CONTROLLER TO CHANGE OUTPUT RESOLUTION
The PM-81HYR camera has PAL and AHD settings by default.
Default settings can be quickly changed by using the camera
programming module (supplied).
The camera programming module has to be connected with the
camera connector as shown in above gure.
NOTE : Please note AHD output will only work with AHD
compatible monitors. CVBS output can work with both
AHD and CVBS compatible monitors.
6.1 "QUICK CHANGE" DEFAULT SETTINGS
5. After the camera is connected with the programming module
and the monitor please follow below steps.
6. Press the Down button for 5 seconds, Camera output will
switch to PAL from NTSC. Repeat the same step to revert to
PAL.
7. Press the LEFT key for 5 seconds, the output of camera will
change from AHD to CVBS. Repeat the same step to revert
to AHD.
6.2 MENU CHANGE INSTRUCTIONS
1. After the camera is connected with the programming module
and the monitor please follow the below steps.
TO CHANGE LANGUAGE (IF REQUIRED) : DEFAULT
LANGUAGE IS ENGLISH.
1. Press the OK key and the screen will change to the MAIN
MENU.
2. Using UP or DOWN key navigate to the item no 7, SPECIAL
and press the OK key which will open up a new sub Menu
page.
3. Using UP and DOWN key go to menu option 5 and press the
LEFT or RIGHT key to change to desired Language.
UP
RIGHT
DOWN
LEFT
RIGHT
BUTTON
MENU
BUTTON
TOP
BUTTON
LEFT
BUTTON
Programming Module Image
DOWN
BUTTON
CAM
(Handheld Programmer)
PM-81HYR cable harness and programmer
12V +
To Monitor