Brochure

Media type WS
Air Flow: Inside to Outside
is rolled stainless steel mesh
element has ID and OD metal
retainers with rolled stainless
steel mesh in between. It is an
extremely robust design. With a
nominal rating of 100 micron, this
media is used for the reduction and
elimination of excess liquids in gas
streams. It also would be a good
choice as a prelter for coalescing
grades 6 and 10 when extreme
volumes of liquid contaminants are
present.
Media type 3P
Air Flow: Inside to Outside
Finite’s 3P pleated cellulose element
removes solid contaminants, with
a 3 micron absolute rating. Because
this element is designed to ow
from its inside to the outside, it has
a strong outer retainer that gives
this element added strength. 3P
particulate “Interceptor” elements
are used where very high dirt loading
is expected but a relatively ne
pore structure is required. It is also
used as a prelter to a coalescing
lter in systems where a lot of solid
contamination exists.
Note1: Tested per ISO 12500-1 at specified inlet content.
Note 2: “*” Indicates suitability in accordance with ISO 8573-1:2010
Note 3: Grades 4C, 6C and XF could be used to achieve Class 1,_,1 if followed by a Grade A oil vapor adsorber.
Note 4: Bulk liquid removal efficiency is given for WS media.
Note 5: Oil vapor removal efficiency is given for A media.
Media
Grade
Coalescing
Efficiency
0.3 to 0.6
Micron
Particles
Micron
Rating
Aerosol
Content
per ISO
12500-1
Maximum
Oil
Carryover
(mg/m
3
)
ISO Class*
Operating
∆P
Recommended
Prefilter
4C 99.995% 0.01 10 0.0005 1,_,2 5.4 - 6.7 10C or 7CP
6C 99.97% 0.01 10 0.003 1,_,2 3.0 - 4.0 10C or 7CP
XF 99.95% 0.3 10 0.05 1,_,2 1.5 - 2.0 7CP
7CP 99.5% 0.5 40 0.2 2,_,3 0.7 - 1.2 WS or 3P
8C 98.5% 0.5 40 0.6 2,_,3 1.0 - 1.4 WS or 3P
10C 95% 1.0 40 2 2,_,4 0.7 - 1.0 WS or 3P
WS 99+% 100 NA NA NA 0.7 - 1.2 NA
3P N/A 3.0 NA NA 3,_,_ 0.7 - 1.2 NA
A 99+% 3.0 NA NA 2,_,3 3.0 - 4.0 6C or XF
Media type A
Air Flow: Inside to Outside
is hydrocarbon vapor removal
element consists of an ultra-ne
grained, highly concentrated,
activated carbon sheet media.
Because these elements are designed
to ow from the inside to their
outside, they have a strong outer
retainer giving this element added
strength. is media type is used
to remove hydrocarbon vapor and
is often used to remove the smell or
taste of compressor lube oil from
breathing air.
Water Separator Element
(removal of bulk liquids)
Interceptor Element
(removal of solids)
Adsorption Element
(removal of odor)
Finite Media Specifications