Product Info
Table Of Contents
- Foreword
- Copyright and trademarks
- Restrictions on use
- Health and safety
- CE type approval
- Park Air Sapphire
- Park Air V2 Services
- About this user documentation
- Glossary of abbreviations, acronyms and technical terms
- 1 Overview
- 2 Description
- 3 Installation
- 4 Amplifier/radio interaction
- 5 Maintenance
- 6 Connector information
- 7 Specification
- 8 Associated equipment
- 9 Fault finding
- Annex
T6-D-USER-AV100-EN Page 3-2 Installation
© Park Air Systems Limited 2020
3.1 Standalone installation
For T6 VHF Transmitter and Transceiver installation instructions, see the relevant product user guide.
The T6 VHF Amplifier must have two suitable AC and/or DC supplies and a suitable antenna.
The AC supply cable specification is shown with AC input connector
on page 6-2 and the DC supply cable
specification is shown with DC input connector on page 6-2.
3.1.1 Connect the cables
(1) M
ake sure the RF cable from the radio to the amplifier is correctly connected.
(2) M
ake sure the antenna cable is correctly connected.
(3) M
ake sure the cables from the radio’s AMP connector(s) are correctly connected.
(4) Make sure the AC and/or DC supply cables are correctly connected.
3.1.2 Switch on the amplifier
Refer to 4 Amplifier/radio interaction for further details.
To make sure the amplifier is operational:
(1) M
ake sure the status Indicator is blue
(2) M
ake sure the correct power supply indicators are illuminated AC and/or DC
(3) D
o an operational test in accordance with local regulations or when required by the user. An accessory
microphone or handset may be required.
AC socket-outlet
The AC socket-outlet must be installed near the amplifier and must have easy access.