User's Manual

M7X and M7R Page 3-24 Operation
Back to Menu
Table 3-3 List of Edit Radio Config Settings
Setting Edit Range Notes
Selectable Frequency
Bands
Depends on waveform See procedure on page 3-29
IP Configuration DHCP, IP address, Subnet mask,
Default gateway, TCP port number
Build State Shows hardware and software build
state
Radio Name Any name containing up to 8
alphanumeric characters
Radio Type M7X or M7R The radio type must be selected
Configured As Transceiver, Transmitter or Receiver See procedure on page 3-27.
Guard Module Fitted or Not fitted
Custom Interface
Module
Fitted or Not fitted
Front Panel Module Control Head Fitted or Not fitted
Brightness Low, Medium or High
Automatic Logout On or Off
Screen Blanking On or Off
Display Timeout On or Off
Front Panel Volume
Config
Speaker, Headset or Both
Speaker Volume 0 to 100% (in 10% steps)
Headset Volume 0 to 100% (in 10% steps)
Sidetone Volume Low or High
Loudspeaker On or Off
Facilities Inhibit On or Off This will show On when a low input signal is
applied to pin 1 of the rear panel Facilities
connector
Software Inhibit On or Off
Inhibit Configuration Receiver, Transmitter or Both
Rx Sensitivity Standard Reserved function
Reference Trim 0 to 100% (in 1% steps)
Reference Select Internal or External