User's Manual

M7X and M7R Page 3-22 Operation
Back to Menu
Configuring the Radio
After all procedures given in the Installation topic have been completed, the radio settings should be
configured. This involves scrolling through the settings listed in Table 3-3 and setting the required values.
After the configuration has been completed, Waveform Profiles and Frequency Presets should be
created and stored.
The procedure to create and store a Waveform Profile is given on page 3-32; the procedure to create
and store a Frequency Preset is given on page 3-36.
Finally and if required, security should be applied. This is detailed on page 3-40.
Some configuration settings must be correctly set to match the physical installation; for
example, the polarities of the PTT signals and whether a transceiver has been configured
as a transceiver, transmitter or receiver. For this reason it is recommended that the
security facility be applied before the radio is put into operational use. Restricting an
operator from changing configuration settings will avoid inadvertent editing.