User's Manual
M7X and M7R Page 5-40 Maintenance
Back to Menu
Radio Config Settings Page
The radio config settings page allows the configuration to be uploaded from a radio, or set and
downloaded to a radio. The parameters are the same as those available from the radio’s front panel; refer
to Topic 3 – Operation.
To upload the Config settings from the radio, at the menu bar select: Get Settings and then Radio Config
Settings. Fig 5-30 shows an empty page that is ready to be compiled. To manually make settings at the
PC, select each field in turn and enter the required value. When complete, download into the radio by
using the Set Settings drop-down menu (see below). If an invalid parameter is entered, a red exclamation
mark (!) is returned when downloaded (because the example in Fig 5-30 is empty, all fields show the
invalid symbol).
Fig 5-30 Radio Config Settings Page
Note:
To make the illustration easier to read, Fig 5-30 shows only part of the Radio Config Settings page.
[Grey fields cannot be
downloaded; the value
is uploaded from the radio.]
All Settings
Radio Config Settings
Freq Bands
IP Configuration
Build State
Waveform Profiles
Frequency Presets
All Settings (excluding Build State)
Radio Config Settings
Freq Bands
IP Configuration
Waveform Profiles
Frequency Presets
Build States
Get Settings drop-down menu Set Settings drop-down menu