User's Guide

Page 2
Back to Transceiver
Main Page
The instructions given in this section involve connecting dangerous voltages to the
transceiver. The instructions detailed in this document must be carried out only by suitably
qualified personnel.
The antenna used with the transceiver must be installed such that the resultant radiated field
strength is below 10 W/m² in areas normally accessible to personnel.
The T6TR transceiver's circuitry contains Electrostatic Sensitive Devices (ESSDs).
Personnel must be aware of the precautions necessary to prevent damage to such devices.
During installation all precautions necessary to prevent ESSD damage must be taken.
Changes or modifications made to this equipment that are not expressly approved by
Park Air, or parties authorized by Park Air, could void the user’s authority to operate the
equipment.
Introduction
The procedures in this document describe how to install a T6TR transceiver. The procedures necessary
during installation are listed in Table 1 and it is recommended that they be completed in the order shown.
Table 1 Installation Procedures
Procedure Reference
1 Perform an initial inspection of the transceiver. see page 4
2 Antenna configuration (if required). see page 4
3 Fit the transceiver into an equipment cabinet. see page 6
4 Connect the remote facilities (as required). see page 7
5 Fit the correct ac input fuse. see page 22
6 Connect the chassis stud to the cabinet or system earth. see page 22
7 Connect the ac supply (if required). see page 22
8 Connect the dc supply (if required). see page 23
WARNING Dangerous Voltages
WARNING
Antenna Radiation
WARNING
ESSDs
Caution Unauthorized Modifications