User's Guide

Page 18
Back to Transceiver
Main Page
AM-Voice Settings Procedure
During this procedure, the following parameters, applicable to AM-Voice operation, can be set:
Audio AGC AM-Voice On or Off On page 19
Loudspeaker AM-Voice On or Off On page 19
Step AM-Voice 8.33, 25 kHz or both 25 kHz page 20
Mic AM-Voice Active or Passive Passive page 20
Key priority AM-Voice
AM-MSK
Local-Remote or
Remote-Local
Local-Remote page 20 and
page 21
Local PTT AM-Voice
AM-MSK
Enabled or Disabled Enabled page 20 and
page 21
Remote PTT AM-Voice
AM-MSK
Enabled or Disabled Enabled page 20 and
page 21
Remote phantom PTT AM-Voice
AM-MSK
Enabled or Disabled Enabled page 20 and
page 21
Self receive AM-Voice On or Off Off page 20
❑ RF power output
❑ Audio Line input level
❑ Audio Line output level
❑ Inhibit
❑ PTT on (key) or off (de-key)
❑ Transmitter time out
❑ Modulation depth
❑ Mute (on or off)
❑ VOGAD (on or off)
❑ Antenna c/o delay (on or off)
❑ Offset
❑ Squelch (See “Squelch Setting Options” on
page 22.)
❑ RF pre-attenuation (on or off)
❑ Squelch defeat (on or off)
❑ Squelch noise compensation (on or off)
❑ Squelch carrier override (on or off)
❑ Audio AGC (on or off)
❑ Loudspeaker (on or off)
❑ Step (25 kHz or 8.33 kHz)
❑ Mic (Passive or Active)
❑ Key priority (local or remote)
❑ Enable or disable local PTT
❑ Enable or disable remote PTT
❑ Enable or disable remote phantom PTT
❑ Self receive
Table 6 Operational Settings from the Front Panel (Continued)
Parameter
Mode Adjustment Range Factory Default Setting Further
Reference