User's Guide

Page 12
Back to Transceiver
Main Page
To Store and Recall Frequency Channels
Up to 100 frequency channels can be stored in the transceiver.
C h 1 0 0
F r e q 1 2 1 . 5 0 0 M H z
R e c a l l
B a c k E x i t
C h 1 0 0
F r e q 1 1 8 . 0 0 0 M H z
S t o r e
B a c k E x i t
C h 1 0 0
F r e q 1 1 8 . 0 0 0 M H z
I nn v a l i d f o r M o d e
B a c k E x i t
C h 1 0 0
F r e q 1 1 8 . 0 0 0 M H z
O u t s i d e B a n d E d g e
B a c k E x i t
To store a Channel Frequency
(1) From the Control screen, select
Channel to display the Channel
screen. Highlight Channel, press the
switch and then turn it until the required
channel number is displayed; press the
switch.
(2) Highlight the MHz frequency value
(see Example 2), press the switch and
then turn it until the required MHz value
is shown. Press the switch.
(3) Highlight the kHz frequency value (see
Example 3), press the switch and then
turn it until the required kHz value is
shown. Press the switch.
(4) Highlight Store and press the switch.
The new frequency is now stored in the
selected channel number.
To recall a Stored Frequency Channel
(1) From the Control screen, select
Channel to display the Channel
screen.
(2) To make the transceiver operate on any
preset channel frequency, highlight
Channel and press the switch. Turn the
switch until the required channel
number/frequency is displayed, then
press the switch.
(3) Turn the switch to highlight Recall, then
press the switch. Exit the screen. The
transceiver now operates on the
recalled channel frequency.
Notes:
If a frequency outside the band edge limits is
entered, a message (see Channel Screen -
Example 3) is displayed.
If a frequency not valid for the mode of
operation is entered, a message (see Channel
Screen - Example 4) is displayed.
Channel Screen - Example 1
Channel Screen - Example 2
Channel Screen - Example 3
Channel Screen - Example 4