User's Guide

T6T VHF 50 W Transmitter Page 4 Installation
Back to Transmitter
Main Page
Configuration
Connection of external equipment depends on the configuration required. Possible configurations are:
❑ T6T transmitter configured for local operation (see Fig 1).
❑ T6T transmitter configured for remote operation (see Fig 2).
❑ T6T transmitter configured for use with MARC (see Fig 3).
❑ T6T Mode 2 configuration (see Fig 4).
❑ T6T Mode 3 configuration. (see Fig 5).
Fig 1 T6T Transmitter Configured for Local Operation
For local operation, the transmitter is operated from the front panel using a microphone/headset.
Any of the optional facilities may be connected.
Antenna
Connector
Reference
Connector
Microphone/Diagnostics
Connector
Frequency Counter
required only for
maintenance
Facilities
Connector
T6T Transmitter
E-BIT input
PTT relay output
External VSWR input
Unregulated supply output
Inhibit input
BIT interruptive test input
Antenna changeover output
Ready output
Tape output
Optional Facilities that
can be used if required
Laptop (or PC) required
only for maintenance
Mic/Headset for
local operation