User's Guide

T6T VHF 50 W Transmitter Page 28 Operation
Back to Transmitter
Main Page
Band Edges
The frequency range of the transmitter is 118 to 136.975 MHz for the B6350/NB version, or 112 to
155.975 MHz for the B6350/WB version.
If required, transmission can be limited to either one or two smaller parts of the frequency band by setting
the band edges BE1 to BE4. Transmission is possible between BE1 and BE2 frequencies, and
frequencies between BE3 and BE4.
Table 8 Band Edge Values
BE1 BE2 BE3 BE4
B6350/NB set so that operation is over the full frequency
range.
118.000 136.975 118.000 136.975
B6350/WB set so that operation is over the full frequency
range.
112.000 155.975 112.000 155.975
Example: Transmitter set to transmit only those frequencies
in the range 120 to 130 MHz.
120.000 130.000 120.000 130.000
Example: Transmitter set to transmit only those frequencies
in the ranges 120 to 125 MHz and 130 to 135 MHz.
120.000 125.000 130.000 135.000
F i l l 3 S o f t w a r e
6 5 - x x x x x x x x / v v
[ D e s c r i p t i o n ]
F i l l 4 S o f t w a r e
6 5 - x x x x x x x x / v v
[ D e s c r i p t i o n ]
65-xxxxxxxx represents the software part number
and /v v represents its version.
65-xxxxxxxx represents the software part number
and /v v represents its version.
B E 1 1 1 8 . 0 0 0 M H z
B E 2 1 3 6 . 9 7 5 M H z
B E 3 1 1 8 . 0 0 0 M H z
E x i t > >
B E 4 1 3 6 . 9 7 5 M H z
E x i t < <
The Band Edge screen is accessed from the
Control screen.
Band edge frequencies can be set only in
increments of 25 kHz.
If the transmitter is required to operate over the
full range, the band edge parameters must be set
to the lowest and highest values in the range (see
Table 8).