User's Manual Part 1
Table Of Contents
- Health and Safety
- Customer Support
- Abbreviations
- Overview
- Specification
- Operation
- Overview
- T6T VHF Amplifier
- Drive Assembly
- Setting Up and Operation
- Normal Operation
- Using the Scroll/Select Switch
- Screen Protocol
- Menu System
- Menu Lock Screen
- Control Screen
- Notes for Setting Up the Transmitter
- Changing the Transmitter’s Operating Frequency
- To Store and Recall Frequency Channels
- To Initiate a BIT Test
- Standby Mode
- Settings
- AM-Voice Settings Procedure
- AM-MSK Mode Settings Procedure
- Mode 2 Settings Screen
- Mode 3 Settings Screen
- Polarities Screen AM-Voice and AM-MSK
- Mode 2 and Mode 3 Polarity Settings
- AM-Voice and AM-MSK BIT Screen
- Mode 2 and Mode 3 BIT Screen
- Software Configuration Screens
- Band Edges
- BIT Status Warning Screens
- Installation
- Warnings and Cautions
- Introduction
- Installing the Transmitter
T6T 300 Watt VHF Transmitter Page 64 Operation
Set microphone
type
(active or passive)
(AM-Voice only)
✔✔ ✗ ✗ ✗✗ Passive
Set keying priority
(local or remote)
✔✔ ✗ ✗ ✗✗
Local-Remote
Enable or disable
local PTT
✔✔ ✗ ✗ ✗✗ Enabled
Enable or disable
remote PTT
✔✔ ✗ ✗ ✗✗
Enabled
Enable or disable
remote phantom
PTT
✔✔ ✗ ✗ ✗✗
Enabled
Radio Settings (Digital Modes)
MAC TM1 (inter
access delay)
✗✔✗ ✗ ✗✔
2.5 ms
MAC TM2 (channel
busy)
✗✔✗ ✗ ✗✔
60 s
MAC p
(persistance)
✗✔✗ ✗ ✗✔
13/256
MAC M1 (maximum
number of access
attempts)
✗✔✗ ✗ ✗✔
135
Scramble vector ✗✔✗ ✗ ✗✔
4D4B
19787
Tx enable ✗✔✗ ✗ ✗✔ On
Polarities
Ready out
✔✔
View
state
✗✗✗
STD
Set PTT input
polarity
(AM modes only)
✔✔
View
state
✗✗✗
STD
Set phantom PTT
input polarity
(AM modes only)
✔✔
View
state
✗✗✗
STD
Continued ...
Table 12 Functions and Parameters (Continued)
Function Front
Panel
VFP MARC T6
Controller
T1/E1 HDLC Default Setting