User's Manual Part 1
Table Of Contents
- Health and Safety
- Customer Support
- Abbreviations
- Overview
- Specification
- Operation
- Overview
- T6T VHF Amplifier
- Drive Assembly
- Setting Up and Operation
- Normal Operation
- Using the Scroll/Select Switch
- Screen Protocol
- Menu System
- Menu Lock Screen
- Control Screen
- Notes for Setting Up the Transmitter
- Changing the Transmitter’s Operating Frequency
- To Store and Recall Frequency Channels
- To Initiate a BIT Test
- Standby Mode
- Settings
- AM-Voice Settings Procedure
- AM-MSK Mode Settings Procedure
- Mode 2 Settings Screen
- Mode 3 Settings Screen
- Polarities Screen AM-Voice and AM-MSK
- Mode 2 and Mode 3 Polarity Settings
- AM-Voice and AM-MSK BIT Screen
- Mode 2 and Mode 3 BIT Screen
- Software Configuration Screens
- Band Edges
- BIT Status Warning Screens
- Installation
- Warnings and Cautions
- Introduction
- Installing the Transmitter
Table of Contents
Page
Page 11
Approvals and Standards 3
Health and Safety 5
Customer Support 7
Abbreviations 9
Overview 15
Purpose 16
Models and Part Numbers 18
Mechanical Installation 18
Operating Parameters 19
Frequency Selection 19
Virtual Front Panel 19
Specification 21
General Specification 22
Variants 22
Number of Channels 22
Frequency Accuracy 22
Power Requirements 22
Dimensions and Weight 23
Transmitter 23
Combiner 23
Environmental 23
AM Modes 24
Transmitter RF Characteristics 24
Output Impedance 24
RF Power Output 24
Duty Cycle 24
Channel Spacing 24
Offset Carrier 24
Harmonic Outputs 24
Spurious Outputs 25
Intermodulation 25
Transmitter Modulation Characteristics 25
Mode 25
Modulation Depth 25
Hum and Noise 25
Frequency Response 25
Distortion 25
Residual FM 26
VOGAD 26
Mute 26
Differential Group Delay 26
Transmitter Control 26
Audio Inputs 26
PTT Time Out 26