Product Instruction

—8—
Instructions
1.Turn On/Off：
2.Sleep Mode：
3 The Eyepiece Dioptre Adjustment .
Enter sleep mode with a short press of Power/Sleep button when the device is
on. Power indicator will keep light when the device enters sleep mode.
The purpose of dioptre adjustment is to get a clear image for users with different
vision. Rotate and adjust the dioptre adjustment ring until you get a clear view of
the four-character icon on the screen. One adjustment only for each eye.
(Please note that the image is not clear normally without the adjustmene
lens.)
—9—
5.IR Fill Light Control
Turn on the device, enter black and white mode with a long press of IR button.
Switch to IR level 1-3 or off with a short press of IR button. The part of fill light is
stretchable which can be twisted out or back to make an quick adjustment.
4.The Objective Lens Adjustment
—10—
6.Red Dot Adjustment
7.Menu operation
Turn on the device, then turn the laser on/off with a long press of Laser/Menu
button. The position of laser can be adjusted on the laser adjustment holes by a
hex-nut wrench.
Enter the menu with a short press of Menu button. Pre
ss +/- button to select
options. Enter a submenu with a short press of OK button. Exit the menu with a
short press of Menu button.
—11—
3. Mount Installation
2.Adjustments
Rotate and adjust the eyepiece dioptre adjustment ring until you can see the
four-character icon on the screen ( there's no need to see a clear image ), then
rotate the Objective lens adjustment ring until you can see the target clearly. Next,
switch to different modes, test IR, Red dot and Rangefinder to check the fun
ction of
the device.
There are five mounting holes in the base of the device. Attach the mount to
the base of the device by using a hex-nut wrench and screws. The mount can be
installed with Picatinny rails.
After entering the ballistic calculation parameter setting, press the menu/ok
button to move up and down to select sub-options and +/- button to adjust the
value of them. To save and return to the observation interface by a long press of
the OK button; return to the observation interface without saving by a long press of
menu button.
Turn on th
e device with a short press of Power button.Turn off the device
witha long press of Power button. Power indicator will keep light when the device is
turned on.
Make sure the eyepiece dioptre adjustment is finished. Aiming at your target,
rotate and adjust the objective lens ring until you get a clear and well-focused
image.
1>BC Setting (Ballistic Calculation)
2>Range Unit Selection
Enter the submenu range unit selection with a short press of OK button. Select
“Meter” or “ Yard” with a short press of +/- button. Confirm your selection wit
h a
short press of OK button.
Enter the byapressofOKbutton, then press "+" or "-" button to
switch among ballistic calculation Parameters/ON/Off options.
.
BC Setting
Confirm your
selection with a short press of OK button
3>PIP (Picture-in-Picture)
Enter the submenu PIP mode with a short press of OK button. Select “off, on,
shortcut key off or shortcut key on” with +/- button. Confirm your selection with a
short press of OK button.
Once the shortcut key of PIP is turned on, enter or exit PIP mode with a long
press of Menu button. (Laser funct
ion can not work in this situation)