User Guide

-7-
In Case of Difficulty
If you believe your unit is malfunctioning, please refer again to these instructions. It's quite easy to
confuse some of the programming functions until you become accustomed to them.
• Disc holder won’t close when disc has been inserted:
-discs are not placed properly in the holder
-disc is warped
• Disc is inserted, but display does not show number of tracks and playing time:
-disc was inserted upside down
-disc is dirty - clean it carefully
-disc is scratched or defective - try another disc
-there is condensation on the laser lens - allow to warm up and dry
• Sound skips or mistracks often:
-changer is exposed to excessive vibration - find better location
-disc is dirty or damaged
• Program function will not operate:
-programming was erased - reprogram the memory
• Hum:
-a cable connection is loose - press cable plugs in tightly
-a cable could be defective - try another cable
• One channel not operative:
-check cable connections
-try another source at your preamp to confirm problem is with your CD changer
• Remote control does not work:
-batteries in remote control are weak or batteries are installed improperly
-there is an obstruction between the remote control and changer
-you are at too great an angle to changer for remote signal to reach it
-there is no disc loaded in the changer
-changer is exposed to bright light which interferes with the remote signal
-changer is exposed to flourescent lights that emit RF that interfere with IR transmission
If you still have difficulty after trying the above, call your Parasound Dealer or custom installer for
further advice. If he cannot help you, call Parasound Technical Service between 8:00 AM and 5:00 PM
PST at [phone]. We may be able to suggest some other diagnostic procedures. If we determine
that the changer must be returned for factory service, we will give you specific instructions, including a
specific Return Authorization number. Pack the unit carefully in both its original carton and its
styrofoam protection and also an outer overcarton for adequate safety. You must mark the Return
Authorization number on the outer carton only; units that arrive without evidence of adequate packing
or without an outer carton or Return Authorization number will be refused. After service we will ship
the unit back to you via UPS.