How to Change the Motor 1. Remove all back cover screws.
. Remove the back cover.
. Remove the spark bar.
. Remove the motor bracket screws.
. Take off the bracket and the screws on the motor. 6. Snip the zip tie connecting the connector to the post. Pull off the rubber connector.
7. Cut the two wires from the motor. 8. Replace the motor, and connect the new wires. NOTE: Use twist-on wire caps, suitable electrical tape or other approved methods of attaching electrical wires.
9. Insert motor post through the bracket. Replace the rubber connector and use a zip tie to secure the connector.
10. Install the bracket on to the side panel. Attach the spark bar. Install the back cover.
