Installation Guide

For technical assistance call 1.800.621.5886 or contact your regional representative

HOW TO CUT SCREWS

Step 1 .

Install the screw into the support plate

and measure the distance between

the bottom of the screw head and

the notch in the support plate.

Step 2 .

Remove the screw. Using a screw

cutter (typically found in the handle

of wire strippers) cut screw to the

correct length.

Step 3 .

Install screw thru the support plate

into the sump until the support plate

(and spacer ring if used) is snug to

the pool surface and there is no gap

behind the support plate.

Step 1.

Step 2a.

Step 2b.

Step 3.