Installation Guide

For technical assistance call 1.800.621.5886 or contact your regional representative
SDX RETRO (VINYL) INSTALLATION
9
1.
Turn off all power to pool or spa and
pump systems. Installation is easiest
when pool or spa is drained. CAUTION
DRAINING A POOL OR SPA MAY
CAUSE STRUCTURAL DAMAGE.
BEFORE DRAINING CONTACT YOUR
LOCAL LICENSED POOL BUILDER
OR REMODELER.
2.
Remove existing drain cover.
(Fig. 1)
3.
Place the SDX retro support plate ring on
a hard surface with the flange up.
(Fig.
2)
Place the SDX retro support plate on
the ring with the groves facing up and
with both hands pushing down, snap the
support plate into the support plate ring.
(Fig. 3)
4.
Place the assembled support plate and
ring over the vinyl sump. Line up the
correct slots with the existing screw
holes that were used for the previous
grate cover. Using the appropriate
screws supplied in the SDX retro kit,
attach the support plate and ring to the
existing sump. Completely hand tighten
screws. Do not use power tools.
(Fig. 4)
CAUTION: IF THE SUMP HAS
BRASS INSERTS IN IT FOR MACHINE
SCREWS DO NOT INSTALL; CALL
PARAMOUNT FOR INSTRUCTIONS. If
you have a Jacuzzi MO series drain use
the long 10-24 pan hd screw. This screw
may need to be cut to fit the application.
(See Pg 5 for instructions on how to
cut screws.)
Fig. 1: Existing Drain Cover
Fig. 2: Support Ring Spacer
Fig. 3: Support Ring and
Plate Snapped Together
Fig. 4: Support Ring and Plate
Screwed to Existing Sump