System information

32
Deploying Parallels Mac Management for Microsoft SCCM 2012
If you are installing all of the components on the same server, select all of them. If you are
installing them on separate computers, select the component(s) you wish to install.
4 Ready to Install the Program. Click the Install button to begin the Parallels Mac Management
for Microsoft SCCM installation.
5 Installing Parallels Mac Management for Microsoft SCCM. Displays the progress bar.
6 Setup Completed. Describes whether the installation was successful or not. Depending on
which components you've selected to install, the page will contain the following:
• If you've selected to install just the Configuration Manager Console Extension component,
the page will contain the Finish button which you can click to finish the installation and close
the wizard.
• If you've selected to install the Configuration Manager Proxy, the page will contain the
Configure Parallels Mac Management for Microsoft SCCM option. Make sure the option
is selected (it is by default) and click Finish. This will close the installation wizard and start
the Parallels Configuration Manager Proxy Configuration Wizard. You may have to wait
a few seconds for the wizard to open. Use the wizard to configure the Configuration
Manager Proxy as described below.
Parallels Configuration Manager Proxy Configuration Wizard
To Configure Parallels Configuration Manager Proxy, complete each page of the configuration
wizard as follows:
7 SMS Provider location. Use this page to specify the hostname or IP address of the server
where the SMS Provider is installed. If the SMS Provider and the Configuration Manager Proxy
are installed on the same server (the server where you are running this wizard), select the Local
server option. If the SMS Provider is installed on a different server, select the Remote server
option and enter the server hostname or IP address.
8 Configuration Manager Proxy service account. Use this page to specify the user account
that should be used to run the Configuration Manager Proxy service. The account must have
read/write access to the SMS Provider. Select the Local System account option to use the
standard Windows LocalSystem account. Select This account to specify a domain account or
a local user account. Use the Password field to specify the account password. For additional
information, see Prepare Your Computers for Installation.
9 Parallels Client certificate management settings. This page is used to specify which
connection type Parallels Configuration Manager Proxy and Mac client will use to communicate
with management point and distribution. The page is also used to configure Windows Public
Key Infrastructure (PKI) integration with Parallels Mac Management.
Note: In order to configure PKI integration on this page, the PKI must be prepared first. The necessary
preparation steps are described in the Configuring Certificate Authorities and PKI Integration
section (p. 20). If you haven't performed those steps but want to use PKI, you need to prepare the PKI
first and then run this wizard again.
Specify the options and values on the page as follows: