Datasheet

ManualsBrandsParallax ManualsBasic Stamp - Educational Boards & KitsBasic Stamp 2

TEKNISK INFORMATION 020-75 80 20 ORDERTEL 020-75 80 00 ORDERFAX 020-75 80 10

TECHNICAL INFORMATION +46 8 580 941 15 ORDERPHONE +46 8 580 941 01 ORDERFAX +46 8 580 941 11

Vi reserverar oss mot fel samt förbehåller oss rätten till ändringar utan föregående meddelande

PRODUKTINFORMATION

ELFA artikelnr.

Antal sidor: 07

Datum 980917

73-192-05 BS1 Starter kit

73-192-13 BS1 Modul

73-193-04 BS2 Starter kit

73-193-12 BS2 Modul

Summary of content (7 pages)

PAGE 1
Datum 980917 PRODUKTINFORMATION TEKNISK INFORMATION 020-75 80 20 ORDERTEL 020-75 80 00 ORDERFAX 020-75 80 10 TECHNICAL INFORMATION +46 8 580 941 15 ORDERPHONE +46 8 580 941 01 ORDERFAX +46 8 580 941 11 Vi reserverar oss mot fel samt förbehåller oss rätten till ändringar utan föregående meddelande ELFA artikelnr.
PAGE 2
PAGE 3
Parallax, Inc. -- BASIC Stamp Modules (comparison table) http://www.parallaxinc.com/stamps/modules.htm BASIC Stamp Modules The BASIC Stamps are available in a number of different package types: PC Board -- The original "Version D" is a complete PC board with prototype area and battery clips.
PAGE 4
Parallax, Inc. -- BASIC Stamp Modules (comparison table) http://www.parallaxinc.com/stamps/modules.htm BASIC Stamp I BASIC Stamp II Version D -- #27100 BS2-IC BS1-IC I/O Lines 8 EEPROM (Program 256 bytes & Data) RAM (Variables) 7 word registers; all are byte addressable, two are bit addressable Max. Program ~80 instructions Length Clock Speed 4-MHz Program Execution 2000 instructions/sec.
PAGE 5
Parallax, Inc. -- PBASIC Instruction Set http://www.parallaxinc.com/stamps/pbasic.htm PBASIC Instruction Set The following gives a complete list of PBASIC commands for both versions of the Stamp. It does not include arithmetic or logical operators. Many enhancements were made to the PBASIC language with the release of the BASIC Stamp II and thus some commands only exist on one version of the BASIC Stamp.
PAGE 6
Parallax, Inc. -- PBASIC Instruction Set http://www.parallaxinc.com/stamps/pbasic.htm REVERSE If pin is an output, make it an input. If pin is an input, make it an output. LOW Make pin output low. HIGH Make pin output high. TOGGLE Make pin an output and toggle state. PULSIN Measure an input pulse. PULSOUT Output a timed pulse by inverting a pin for some time. BUTTON Debounce button, perform auto-repeat, and branch to address if button is in target state.
PAGE 7
Parallax, Inc. -- PBASIC Instruction Set http://www.parallaxinc.com/stamps/pbasic.htm EEPROM Store data in EEPROM before downloading BASIC program (Stamp D and BS1-IC) READ Read EEPROM byte into variable. WRITE Write byte into EEPROM TIME PAUSE Pause execution for 0 to 65536 milliseconds. POWER CONTROL NAP Nap for a short period. Power consumption is reduced. SLEEP Sleep for 1 to 65535 seconds. Power consumption is reduced to 20 µA (Stamp D and BS1-IC) or 50 µA (BS2-IC).