Ping mounting bracket documentation v2.0

Copyright © Parallax, Inc. • PING))) Bracket Kit (#570-28015) • v1.1 8/10/2007 Page 2 of 4
Step 2:
Attach the PING))) mounting bracket to the
servo horn using (2) 2/56 ¼” long screws
and nuts. Put the rubber grommet in the
bracket’s larger hole.
Step 3:
The mounting holes on the PING)))
mounting bracket accommodate both
Futaba and Hitec servo sizes and locations.
Identify the proper holes for your servo.
Step 4:
As viewed from the top, attach the PING)))
ultrasonic sensor to the PING))) mounting
bracket using (2) 4/40 ½” long screws, (2)
¼” long nylon spacers and (2) 4/40 nuts.
Step 5:
Disconnect power, then remove the Board
of Education
®
and four standoffs from the
Boe-Bot chassis. The Board of Education’s
front right mounting position will be used
for the straight bracket attachments; the
other one will mount on one of the
chassis’s front slots using a 4/40 ¼” screw
and nut. Install (3) nylon washers under
the other three standoffs and replace the
Board of Education on the chassis so it
remains level.