XBee Adapter Board documentation

Copyright © Parallax Inc. XBee Adapter Board (#32403) v1.0 2/1/2010 Page 3 of 4
Step 3:
Using an Exacto knife,
hobby knife or a pair of
diagonal cutters, cut two 11-
pin headers from the 40-pin
header. Extra header
material was included in
case of a mistake or
damaged header.
Step 4 (optional):
Insert the two 11-pin SIP
headers into the bottom of
the adapter board as shown
and solder them in place
from the top.
This step is optional in that
you could leave the headers
out and solder wires into the
pads instead if you wish.