Datasheet

Chapter 3 Assemble and Test your BOE Shield-Bot
82Robotics with the BOE Shield-Bot
Insert the two Nylon flat-head screws through the inside of the battery pack. Use
the smaller set of holes that line up with the chassis mounting holes for the front
standoffs.
From the top of the chassis, thread a 1" standoff on each screw and tighten.
Pull the battery pack’s power cord and servo lines through the rubber grommet
hole in the center of the chassis, as shown below.
Mount the Wheels
Parts List
(1) 1/16″ cotter pin
(1) tail wheel ball
(2) O-ring tires
(2) plastic machined wheels
(2) screws saved when removing the servo horns